Diamond Dermabrasion Facial Peeling Machine (M022A)

Introduction:
Microdermabrasion is a mechanical form of exfoliation of the outer dead layers of skin. The fine metal particles on the handle tips will remove dead layers in back and forth movements on skin surface, and then the layers will be sucked into the filter bottle by vacuum.

Application:

1. remove dead skin surface, scars and so on

2. stimulate cell growth

3. smooth skin

Spare part:
3 stainless steel wands which are used with 9 interchangeable diamond tips
1. The higher the D number, the finer the grit
2. Clean diamond tips with Alcohol, then sterilize them with UV light or high Temperature
3. Replace the cotton filter inside the diamond tip or gas nipple after 5-6 customers treatment

Preparation before treatment:
1. A consultation included the examination of the skin, a plan for treatment
2. Operator should wear vinyl gloves and a facemask
3. On oily or acne skin, a steamer may be used prior to the treatment, or a degreasing lotion may be applied prior to the cleanser
4. Cleansing the skin with Cleansing gel or water, then wipe off with cotton pad. Allow the skin to dry
How to use:

1. Push in the movable ring of copper nozzle at the hand piece, and pull out the 6x4 size vacuum hose. Then push in the black plastic ring on the vacuum hose
2. Put a drop of cream or milk lotion on the vacuum hose nozzle, push in the movable ring and insert in the vacuum hose to the limit
3. Insert a cotton swab into the Diamond Head, then tight up the Diamond Head on the hand piece. Remove the cotton swab after every treatment
4. Turn on the power switch
5. Adjust the Vacuum intensity by Vacuum Regulator according to the following reference table, the intensity displays on Vacuum gauge and check with the client for comfort
6. Use the incline area of Hand piece to contact with the skin surface. Proceed with a slow sliding motion. Do not place the hand piece at one spot for too long, doing so will cause harm to the skin
7. Adjust the crystal flow rate by the Vacuum Regulator slowly from minimum to maximum. For commonly use, do not set the flow rate to maximum unless it is of necessity. This is for better comfort intensity
8. Gently stretch the skin with thumb and finger and glide the Hand-piece 2 to 3 times over the area being treated. Then cross again in different directions to prevent streaking lines as in the reference picture. Brush strokes or polishing motions may be used in different sites
9. After treatment, brush off all remaining dead skin with a soft brush and rinse with damp sponges or damp cool towel
10. Allow skin to dry then apply desired skin product
11. To clean the Diamond Head, use toothbrush or cotton swab damped with a little alcohol to wipe off the dirty impurity, and then use UV light or high temperature for sterilization
Recommended Vacuum Intensity:

Treatment Schedule Table:

Notice:

1. Always begin treatment conservatively and observe the effects by the touch and appearance of the skin. A vacuum power that is too high or too big may cause an inflammatory response
2. Edema and erythema can occur following treatment, but will resolve in few hours
3. Overly aggressive techniques can cause mild flaking over the next 3-4 days. Epidermis that is treated too aggressively can lead to bleeding in the superficial dermis
4. Diamond Dermabrasion should not be used on sensitive areas such as eyelids. The eyelids should be closed at all times during the procedure and may be covered with damp cotton pads
5. The following areas are considered inappropriate for treatment: Skin tumor, moles, birthmark, angioma, lips, eyes, herpes, skin cancer, and liver spots
6. Do not modify or attempt to repair the machine, contact the technician for maintenance

Specification:

Voltage: 110V/ 220V
Frequency: 50Hz/ 60Hz
G.W: 7kgs
Package size: 57*43*29cm